How to install the wiring of the smart switch socket? Socket three-wire wiring method: connect one A mark of the 2 holes of the switch at the front, and then connect the insulated wire from the other hole to the L hole of the 3 holes of the lower socket and connect it firmly. The neutral wire is directly connected to the N hole of the 3 holes of the socket and connected firmly. The ground wire is directly connected to the E hole of the 3 holes of the socket and connected firmly. If the neutral wire is wrongly connected to the ground wire, a tripping phenomenon may occur when the electrical appliance is used.
Switch socket fixing device: first pass the wire thrown out of the box through the outlet hole of the plastic table, and then fix the plastic table close to the wall with screws on the box. After fixing, pass the wires out of the wire hole of the switch socket according to their respective positions, and press the wires firmly according to the wiring requirements. Then stick the switch or socket on the plastic table, align it and fix it firmly with screws, and cover the decorative board.
Power cord processing: Leave the wire thrown out of the box for repair length, and then cut the wire core, take care not to damage the wire core. Wind the wire clockwise on the corresponding terminal of the switch or socket, and then tighten the indenter so that the wire core must not be exposed. Switch socket bottom box cleaning: switch socket installation is carried out after carpenter painters, etc., and the long-placed bottom box inevitably accumulates a lot of dust.
When the smart switch socket is installed, the bottom box of the switch socket is cleaned first, which is to clean up the dust and impurities in the box, and wipe the remaining dust in the box with a damp cloth. Doing so can prevent special impurities from affecting the condition of the circuit.
